Skip to content
Marando ServiceTederic Italia

↑ ↓ to move · Esc to close

Catalogue

NEO·T

High-end hydraulic toggle, from low tonnages to large molds.

Clamping force90 – 2,200t
ClampingToggle
DriveHydraulic
Tederic NEO·T injection molding machine, side view

A toggle series with hydraulic drive, built around a high-rigidity moving platen and twin linear guides: the geometry stays stable even with heavy molds, and part repeatability holds within half a percentage point.

The manufacturer declares a 30% to 80% reduction in consumption compared with a conventional hydraulic system, and a pressure response of around 28 milliseconds, with system pressure at 17.5 MPa. The injection unit swivels and lubrication is automatic.

The declared clamping force range runs from 90 to 2,200 tonnes.

Technical data

Technical data

Clamping unit


Clamping force
90 – 2,200t
Clamping structure
Toggle
Moving platen guides
Twin linear guides

Injection unit


Injection unit
Swivelling
Speed increase, small machines
+15 – 30%
Speed increase, large machines
+5 – 10%

Declared performance


Drive
Hydraulic
System pressure
17.5MPa
Response time to maximum pressure
28ms
Part repeatability
< 0.5%
Energy saving versus conventional hydraulics
30 – 80%
Lubrication
Automatic

Figures declared by the manufacturer, taken from official Tederic documentation. They are not contractually binding: a written quotation prevails.